![]() ![]() Apply a rope of plumber’s putty to the underside of the threaded strainer body’s flange. Position the rubber gasket on the drain-tube elbow. Position the drain tube and elbow under the tub.Ģ. The tube has a rubber gasket that seals it to the outside of the tub, held in place by a retainer plate on the inside of the tub. Before setting the tub, elevate it with scraps of wood and install the waste-and-overflow tube. ![]() Also check to see that the drain hole (or outlet) is in the same position as the old tub if not, you will have to modify the drain lines.ġ. If the new tub is narrower than the old one, you may need to patch or redo the bathroom flooring. (5 ft.) long, but check to be sure you may need to buy a 66-incher or another size. TIP: Be sure to buy a tub with either a right- or left-hand drain to match your plumbing. If there isn’t an adjacent wall or ceiling that you can reach the drain assembly from after the tub is in place, you can buy some tubs with removable front panels that give access to make drain connections. ![]() In the situation shown here, there is easy access to a trap from below, so you can install the assembly before dropping in the tub. Carefully plan how you will attach the waste-and-overflow assembly, especially at the tub’s drain hole. This article shows how to install a tub that has its drain hole in the same place as the old tub you are replacing. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |